FARMSCAN Jackal v2, Руководство пользователя

Страница: 5 / 28

AM-Jackal-2 more quick guides @ www.farmscanag.com/jackal July 2013
3 Connections
CONNECTIONS
The connector on the rear of the Jackal has the following connection points available for use.
AVAILABLE CONNECTIONS
A1 GND (Ground/Earth/0V) B1 IN1 (1x Coil Input ONLY /Prox/Reed sensor)
A2 IN13 (Prox/Reed/Switch/Alarm) B2 IN2 (Prox/Reed/Switch/Alarm)
A3 IN12 (Prox/Reed/Switch/Alarm) B3 IN3 (Prox/Reed/Switch/Alarm)
A4 IN11 (Prox/Reed/Switch/Alarm) B4 IN4 (Prox/Reed/Switch/Alarm)
A5 IN10 (Prox/Reed/Switch/Alarm) B5 IN5 (Prox/Reed/Switch/Alarm)
A6 IN9 (Prox/Reed/Switch/Alarm) B6 IN6 (Prox/Reed/Switch/Alarm)
A7 IN8 (Varying volt sensor) B7 IN7 (Varying volt sensor)
A8 Not Used B8 Out1 (Solenoid/Shutoff/Pulse/Radar output ) – Pulls to GND
^
A9 Not Used B9 Out2 (+12V Supply Out) – Sensor Power ^^
A10 RS232 Tx (Transmit) B10 BATT +VE (+12V Battery Terminal)
A11 RS232 Rx (Receive) B11 BATT -VE (0V/GND Battery Terminal, Vehicle Ground)

^ B8/OUT1 is Open Circuit when the output is NOT ACTIVE, and is connected to GND when the
output is active

^^ B9/OUT2 will only power the sensors when the unit is turned on

Any Inputs 1-13 can be used as remote/run hold