Farmet SOFTER 8 8 PS, Руководство по эксплуатации

Страница: 29 / 52

COMMISSIONING
8.3.1 Machine unfolding procedure
Machine unfolding procedure – work position
Initial position: The machine is lifted on the axle, the side frames are secured with the drawbar and belt,
both ball valves outside are closed.
1
Remove the drawbar securing,
place them on the pole. Open both
ball valves located on the drawbar.
Unfold the machine using the red
circuit.
2
Draw out the piston-rods of the
side rollers using the yellow circuit
into the marginal position, i. e.
maximum release.
Draw in the piston-rods of the axle
using the green circuit into the
marginal position, i. e. maximum
insertion. The machine will rest on
all rollers equally.
Place the relevant number of
spacer rings on the roller piston-
rods and set the tracing wheel
(according to the required recess
of the machine). If the machine is
equipped with a drawbar for fixed
suspension,
set the distance
washers also on the drawbar piston
rods. Draw in the piston-rods of all
rollers (drawbar) using the yellow
circuit. The machine is ready for
work.
SETTING THE DOWN PRESSURE OF SIDE FRAMES
• When the machine has been unfolded, the down pressure of the side
frames must be adjusted to ensure optimal terrain tracing.
• Set the value of 100 bar (1450 Psi) on the pressure gauge using the
circuit for unfolding.
29 | 52