Manual
SOFTER 4,5 NS | 6 NS
13
│
21
Edge disc
Edge disc
Side deflector
Side deflector
Third point TPS –
Setting of machine
longitudinal plane
Nastavení
pracovní hloubky
Nastavení
pracovní hloubky
Nastavení
pracovní hloubky
Working depth
adjustment
4.
MACHINE TRANSPORT ON ROADS
Transport Position of
SOFTER 4,5 NS a 6NS
Connect the machine by suspending on the tractor using the three-point suspension equipment.
Bring the machine into the transport position ad chapter 3.3.
The side frames must be secured with the connecting rod.
The machine must be equipped with removable shields with marking of contours, functional
lighting, and the board of the rear marking for slow vehicles (according to ECE No. 69)
The lighting must be activated during travelling on roads.
The tractor must be equipped with a special light device of an orange colour, which must be
activated during travelling on roads.
Secure the lower shoulders of the tractor TPS from side swing.
The maximum transport speed during travelling on roads is
25 kph.
Ban of transport with decreased visibility!
The operator is obliged to pay increased attention during transport on roads, due to the transport dimensions
of the machine.
The operator must observe the valid regulations for transport on roads (laws, decrees) after connecting the
machine to the tractor, for reason of a change of the axle load. The driving properties of the set also change
depending on the terrain nature, adapt the manner of driving to these conditions.
Only machines with a valid technical certificate issued in accordance with the valid regulation on the
approval of technical qualification and operation on public communications as amended may be transported
on public communications. Machines without a valid technical certificate may only be transported on
public communications when carried by a towed trailer or other approved means of transport in accordance
with the valid regulation.
The operator is obliged to secure sufficient outlook during reversing from his position of the tractor driver.
In case of insufficient outlook, the operator is obliged to call a competent and informed person.
The operator must secure the arms of the rear TPS of the tractor in the transport position during road
transport, i.e. prevent unexpected arm drop using the hydraulic arm control lever. At the same time, the
arms of the rear TPS of the tractor must be secured against side swinging.
During machine transport on roads, the operator must observe the valid laws and decrees that deal with this
topic and which specify the relationships of the tractor axle load depending on transport speed.
Clean the entire machine from any accumulated soil before the transportation on the road.
5.
MACHINE ADJUSTMENT
Disc plough-harrow is attached to the three-point suspension in the usual way. The lower arms of the
hydraulic system must be at the same height from the ground. The working depth of the discs is within the
range of 3.5 to 12 cm. The working depth range could be reduced due to wear on the discs. The working
depth must be adjusted according to the land type and the soil conditions.
It is not permissible for the
bearing housings to be touching the soil surface during operation.
Fig. 6 – machine adjustment spots
