Manual
KOMPAKTOMAT K500PS | K600PS | K700PS | K800PS | K1000PS
8
│
56
A.6
(18)
During machine work in the field or during transport, the operator must control the machine from the
tractor's cabin.
A.7
(19)
The operator may enter the machine structure only with the machine at rest and blocked against
movement, namely only for these reasons:
(20)
Adjustment of the machine working parts,
(21)
Repair and maintenance of the machine,
(29)
Release and securing of spherical valves of the axle,
(27)
Securing of spherical valves of the axle before folding the side frames,
(28)
Adjustment of the working parts of the machine after unfolding the side frames.
A.8
(xxx)
When stepping on the machine, do not step on tyres of the axles or other rotary parts. Those may
turn and you can cause very serious injuries by the subsequent fall.
A.9
(22)
Any changes or modifications of machine may be performed only with written consent of the
manufacturer. For possible damage arisen due to ignoring this instruction, the producer bears no
responsibility. The machine must be maintained equipped with prescribed accessories and equipment
including safety marking. All warning and safety signs must be legible and in their places. In case of
damage or loss, these signs must be immediately renewed.
A.10
(23)
The operator must have the Operating Manual with the work safety requirements available at any
time when working with the machine.
A.11
(24)
The operator must not consume alcohol, medicines, narcotic and hallucinogenic substances that
decrease his attention and coordination capabilities while using the machine. If the operator must use
medicines prescribed by a physician or uses freely sold medicines, he must be informed by a physician,
whether he is capable of responsible and safe operation of the machine under these circumstances
PROTECTIVE TOOLS
For the operation and maintenance use
:
Tight clothes
Protective gloves and goggles for protection against dust and sharp parts of the machine
B.
MACHINE TRANSPORT USING TRANSPORT MEANS
B.1
(1)
The transport means designed for machine transport must have the load capacity minimally identical
with the weight of the transported machine. The total weight of the machine is stated on the production
label.
B.2
(2)
The dimensions of the transported machine including the transport means must comply with the valid
regulations for road traffic (decrees, laws).
B.3
(3)
The transported machine must be always fastened to the transport means so that its spontaneous
loosening could not happen.
B.4
(4)
The carrier is responsible for damage caused by the loosening of incorrectly or insufficiently fastened
machine to the transport means.
B.5
(xx)
The carrier shall observe the instructions of the responsible employees of Farmet in charge of loading
concerning proper binding and securing of the machine on the transportation vehicle, particularly with
regard to the potential damage of the machine to be transported.
