Manual
KOMPAKTOMAT K500PS | K600PS | K700PS | K800PS | K1000PS
49
│
56
10.2
REPLACEMENT OF WORN SHARES
Always observe the safety regulations and instructions when replacing shares.
The machine must be aggregated with the tractor according to chapter 5.1/p.20 when shares are replaced.
The tractor must be turned off and the operator or repairer must prevent free access of unauthorized
persons to the tractor.
Replace the shares on solid and even surface and when the machine is standing still.
If the hydraulic system of the tractor is not tight, you have to provide mechanical supports for the machine
pole.
10.2.1
REPLACEMENT OF WORN SHARES ON THE CENTRAL FRAME
Only for combinators
K500PS, K600PS, K700PS, K800PS, K1000PS.
Place the machine into the transport position according to chapter 5.3.1/p.26.
Lift the rear arms of the tractors TPH with the aggregated machine to the maximum position and
secure it against falling. Then you can replace the worn shares.
Replacement of shares on the central frame
10.2.2
REPLACEMENT OF WORN SHARES OF THE SIDE FRAME
Place the machine into the transport position according to chapter ¨5.3.1/p.26.
Replace the shares you can reach.
To replace shares you cannot reach, unfold the side frames into the position when they are almost in
the working position. In this position secure the side frames by a mechanical support against
unexpected fall.
When the side frames are secured, you can start replacing the shares.
Replacement of shares on the side frames
10.3
SPECIFICATION OF SPARE PARTS FOR AXLES
To provide proper specification of spare parts, it is required to take a photo of the axle label and include the
production number of the machine. It will make the proper specification of the spare part easier and faster.
Maximally lifted and
secured shoulders of
the tractor TPS
Maximally lifted and
secured axle
