Farmet KOMPAKTOMAT K1000PS, Руководство по эксплуатации

Страница: 42 / 56

Manual
KOMPAKTOMAT K500PS | K600PS | K700PS | K800PS | K1000PS
42
│
56
9. AGGREGATION WITH OTHER EQUIPMENT

Semi-carried Kompaktomat machines can be optionally equipped with a rear three-point hitch TPH for
aggregation with other equipment. Other equipment means carried equipment, such as crumbling
rollers with cross-kill wheels, pneumatic drill machine or mechanical drill machine.

Only equipment that allows continuous tracing of the terrain can be aggregated with Kompaktomat. It
is not possible to aggregate, for example, a drill machine without travelling wheels.

Only machines with the same working coverage as the Kompaktomat can be aggregated.

When aggregating Kompaktomat and additional machine, always observe safety regulations and
exercise increased caution.

Perform aggregation on a flat and reinforced surface. Aggregation requires the assistance of another
trained worker who will help you.

It is only allowed to enter the area between the Kompaktomat and additional machine when both
machines are in standstill.

The aggregated machine changes the load on the Kompaktomat axle and the properties of driving,
therefore exercise increased caution when driving with the set of Kompaktomat and aggregated
machine.

When driving such a set, always observe valid road traffic regulations.

When working with the set of TRACTOR

KOMPAKTOMAT

OTHER EQUIPMENT, always observe the
labour safety rules for working with Kompaktomat and another machine as well as the rules of safe road
transportation.
K1000PS with DV1000 crumbling rollers K600PS with Monsun ME600 drill machine

When Kompaktomat is aggregated with another machine, the load of the Kompaktomat axle changes.
Only additional machines that do not overload the transport axle of Kompaktomat can be aggregated.
Follow the table below.
Maximum Permissible Weight of Another Machine for Aggregation with Kompaktomat
K500PS K600PS K700PS K800PS K1000PS
F
t
(kg) 4025 4360 4960 5345 6920
F
n
(kg) 5950 6800
K1 (mm) 3895 3810
K2 (mm) 5750 5950
Centre of gravity Maximum weight of equipment "M" (kg) at transport speed of 25 km/hour
L= 1000 mm 2746 2553 2930 2708 2028
L= 1300 mm 2629 2444 2806 2593 1944
L= 1500 mm 2557 2377 2728 2522 1892
L= 1700 mm 2488 2313 2655 2454 1842
L= 2000 mm 2392 2223 2552 2359 1773
K1...dimension invariable no.1; K2...dimension invariable no.2;
F
t
…weight of the machine in the centre of gravity; F
n
…maximum permissible axle load

The calculated value (weight) "M" will help you check the possibility of trouble-free aggregation of
another machine with Kompaktomat.

Formula for the calculation of the maximum permissible weight of additional equipment for aggregation
with Kompaktomat: