Farm King BW200, Руководство оператора и каталог запасных частей

Страница: 26 / 82

Operation - 200 Bale Wrapper
24
COMMISSION/PROGRAM THE
COUNTER FOR FIRST TIME USE
The commissioning of a newly purchased bale
wrapping machine should be performed under
the supervision of an experienced operator or a
dealer service representative.
Before commission, familiarize yourself with the
following manual, paying special attention to the
sections regarding the safety of the operator and
bystanders.
IMPORTANT
It is only possible to enter the manufacturing year
and serial number once.
After the information is confirmed, it cannot be
corrected.
To stop the data entering procedure, disconnect
the counter from its power source. The wrap
counter data cannot be erased and no changes
can be made.
The wrap counter shall be installed in the tractor
cabin, connected to the revolution sensor and
plugged to the electric power source by using the
power cable.
The proper connection is signaled by a blinking
red light on the counter display. Press and hold
the button (activation symbol C).
Each activation of the counter is accompanied by
the display test and power supply voltage test.
The display will show the indication 8888 and all
decimal points and LEDs will light up. The sound
signal will be activated.
The power source voltage will be displayed (Ex.
U12.7, which denotes voltage of 12.7 V). Any other
condition indicates that the counter is damaged.
The year of manufacture of the counter will be
displayed (Ex. 2011) and a yellow LED will light
up.
Use the F2 button to enter the manufacturing
year of the wrapping machine (between 2000 and
2099).
Check if the entered data is correct by pressing
the F1 button. It should display the manufacturing
year and the wrapping machine serial number
interchangeably.
If the entered data is correct, confirm using the
on/C button by pressing and holding it for about
10 seconds.
The confirmation of the entered data will be
signaled by a blinking red LED and intermittent
sound signal.