DC/IN
NET
NET
Product View
Quick Installation Guide
Day&Night IP Camera
Connect IP Cam to Internet
Installation CD
1. Connect the power adapter.
2. Connect the Ethernet cable to the NAT/Router.
3.The IP camera will get IP address from the NAT/Router (with DHCP
enabled) automatically and connect to internet. Check if the red
LED of IP camera is always on. If it’s blinking, please check step 1
and step 2 again.
Install CamView Software
Put the Installation CD into your computer(with Windows XP/Vista/7).
After the setup menu opened, select “Install Management Software” and
follow the directions as prompted.
Step 1.
Step 2.
Installation Guide
IP Cam
NAT/Router
Internet
Ethernet Cable
Power Adapter
SD
WPS
Quick Installation Guide
Day&Night IP Camera
SD
WPS
SD
WPS
SD
SD
WPS
IR LED
Microphone
WPS Button
(Wireless model)
Night Time Lens
Day Time Lens
Micro-SD Card
Indication LED
Ethernet Indication LED
Status Indication LED
PIR
Reset Button
[ Front View ]
[ Back View ]
[ Bottom View ]
[ Right Side View ]
Micro-SD Card Slot
Speaker Jack
SPK
DC/IN
NET
NET
Power Jack
Bracket Screw Jack
Ethernet Jack
WPS
ID
Password
IP Cam
QIG
Bracket
Anchors
and Screws
Installation CD ID/Password Card
Power Adapter
Ethernet Cable
Package Contents
Hardware Installation
SPK
SPK
Use "Allen Key"
counterclockwise to loosen
the screw a little.
Embed the bracket in the
mounting hole, and adjust it
to the appropriate angle.
Use "Allen Key" clockwise
to tighten the screw.
SPK
Allen Key
A
A
A
B
B
B
A
B
