FOR RESTRICTED USE only
Fargo Electronics, Inc.
DTC550 Direct to Card Printer/Encoder User Guide (Rev. 2.8)
1-10
Reviewing the Lamination Module Sequence of Operations
The LAM sequence of operations begins after printing has occurred with the Card Printer.
Step
Process
1
The card is fed onto the Lamination Module Flipper Table.
2
The card is fed to the Card Position Sensor.
3
The Lamination Ribbon Motor begins cycling until the Upper Lamination
Sensor detects the mark.
4
The Card Feed Motor activates to center the card on the Platen Roller.
5
The Lamination Roller Lift Motor cycles until the Lamination Roller Lift Sensor
detects state change.
6
The Card Feed Motor and the Lamination Ribbon Motor activate for the
length of the card.
7
The Lamination Roller Lift Motor cycles until Lamination Roller Lift Sensor
detects state change.
8
The card is fed back to the Flipper Table.
9
The Flipper Table Clutch engages.
10
The Flipper Table Motor activates until the Card is inverted based on the
Flipper offset setting.
11
The Flipper Table Clutch disengages.
12
The card is fed off the Flipper Table.
13
The Flipper Table Clutch engages.
