28
When the VPN connection established, the VPN IP Address should be displayed in the VPN status.
There may be some delay of the connection establishment. User may need to refresh the page to
update the status.
Once the VPN is configured, the device will try to connect with the VPN automatically when the device
boots up every time until user disable it. Sometimes, if the VPN connection does not establish
immediately, user may try to reboot the device and check if VPN connection established after reboot.
◼
OpenVPN
To establish an OpenVPN connection, user should get the following authentication and configuration
files from the OpenVPN hosting provider and name them as the following,
OpenVPN Configuration file:
client.ovpn
CA Root Certification:
ca.crt
Client Certification:
client.crt
Client Key:
client.key
User can upload these files to the device in the web page [Network] >> [VPN], select OpenVPN Files.
Then user should check “Enable VPN” and select “OpenVPN” in VPN Mode and click “Apply” to
enable OpenVPN connection.
Same as L2TP connection, the connection will be established every time when system rebooted until
user disable it manually.
9.12 Network >> Web Filter
A user can set up a configuration management device that allows only machines with a certain
network segment IP to access the configuration management device
Picture 24 - WEB Filter Table
Add and remove IP segments that are accessible; Configure the starting IP address within the start IP,