Fanvil FH-S01, Руководство пользователя

Страница: 21 / 63

16
MCAST Dynamic
：
Description: send multicast configuration information through SIP notify signaling. After
receiving the message, the device configures it to the system for multicast monitoring or
cancels multicast monitoring in the system.
8.3 Hotspot
SIP hotspot is a simple utility. Its configuration is simple, which can realize the function of
group vibration and expand thequantity of sip account. Take one device A as the SIP hotspot
and the other devices (B, C) as the SIP hotspot client. When someone calls device A, devices A,
B, and C will ring, and if any of them answer, the other devices will stop ringing and not be able
to answer at the same time. When A B or C device is called out, it is called out with A SIP
number registered with device A.
Table 5 - SIP Hotspot
Parameters Description
Enable Hotspot Enable or disable hotspot.
Mode This device can only be used as a client.
Monitor Type The monitoring type can be broadcast or multicast. If you want to
restrict broadcast packets in the network, you can choose multicast.
The type of monitoring on the server side and the client side must be
the same, for example, when the device on the client side is selected
for multicast, the device on the SIP hotspot server side must also be
set for multicast.
Monitor Address The multicast address used by the client and server when the
monitoring type is multicast. If broadcasting is used, this address does
not need to be configured, and the system will communicate by
default using the broadcast address of the device's wan port IP.
Remote Port Fill in a custom hotspot communication port. The server and client
ports need to be consistent.
Name Fill in the name of the SIP hotspot. This configuration is used to
identify different hotspots on the network to avoid connection conflicts.
Line Settings Sets whether to enable the SIP hotspot function on the corresponding
SIP line.
Client Settings
：
As a SIP hotspot client, there is no need to set up a SIP account, which is automatically
acquired and configured when the device is enabled. Just change the mode to "client" and the