10
How to Assemble the Blades and Light Kit
x 10
3/16-24 x 10 mm
PHILLIPS HEAD
SCREWS
HARDWARE USED:
x 10
1/4-20 x 14mm
SCREWS
HARDWARE USED:
Figure 18
Figure 19
Figure 20
1.
Position the blade over the blade holder with
threaded posts showing. Make sure the bottom
edge of the blade is fully seated against the blade arm.
With a Phillips screwdriver, tighten 3/16-24 x 10 mm
e
d
a
l
b
e
h
t
o
t
e
d
a
l
b
e
h
t
e
r
u
c
e
s
o
t
s
w
e
r
c
s
d
a
e
h
s
p
il
li
h
p
arm (Figure 18).
2.
Secure the blade holders to the motor support
using the 1/4-20 x 14 mm screws through the holes
located on the side of the motor support (Figure 19).
NOTE:
NOTE:
Periodically check blade holder hardware and
resecure if necessary.
3.
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
Blade Holder Arm
Blade Holder
Cover
Light Plate Assemby
Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws.
Assemble the light plate assembly
to the support
bracket using the two key slots in the socket plate.
Replace the third screw and securely tighten all three
screws (Figure 20).
