Fanimation TF9070TS, Руководство пользователя

Страница: 8 / 14

Assembling and Mounting the Fan Blades
8
Assembling and Mounting the Fan Blades
Remove and discard the (rubber) motor “stops” by removing
the five screws. (Figure 1)
Blade & Blade Holder Assembly:
1.
Lay flat side of blade holder arm on a flat surface with
the inside of the blade holder arm facing up. This is the
side with the threaded posts and pitched foot.
2. Position the blade over the blade holder with the threaded
posts showing. Make sure the bottom edge of the blade is
fully seated against the blade holder arm.
3. With a Phillips screwdriver, tighten screws with flat
washers to secure the blade. (Figure 2)
4. Attach Blade Holders to the Motor Hub using the Screws
w/Lock washers as shown in Figure 3.
5. Make sure the screws with lock washers securing the
Blade Holders to the Motor Hub are tight and that the
Blade Holders are properly seated. (Figure 3)
NOTE: Periodically check Blade Holder hardware and re-
secure if necessary. (see Maintenance)
Figure 3
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
Blade
Blade Holder
Arm
Figure 2
Figure 1
▲ WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
Installing the Switch Cup Assembly
1. Securely attach the 9-pin switch cup connector to wiring
harness socket within Switch Cup Assembly. (Figure 1)
Figure 1