8
How to Assemble Your Ceiling Fan (continued)
Figure 6
Figure 7
6.
Reinstall the hanger ball on the downrod as
follows. Route the three 80-inch wires through the
hanger ball. Position the pin through the two holes
in the downrod and align the hanger ball so the pin
is captured in the groove in the top of the hanger
ball. Pull the hanger ball up tight against the pin.
Securely tighten the set screw in the hanger ball.
7.
Cut off excess lead wire approximately 6 to 9
inches above top of the top of the downrod. Strip
insulation off 1/2-inch from the end of each lead
wire (Figure 7).
NOTE: All set screws must be checked, and retightened
where necessary, before installation.
A loose set screw could create fan wobble (Figure 6).
