Fanimation Levon FP7910OB, Руководство пользователя

Страница: 8 / 14

8
Assembling and Mounting the Fan Blades and Switch Hsg
1. Remove and discard the (rubber) motor “stops” by
removing the screws. (Figure 1)
Blade & Blade Holder Assembly:
2.
Lay the side of the blade holder on a flat surface with the
inside of the blade holder facing up.
3. Assemble the blade to the blade holder with the carriage
nuts, flat washer, and screws. Make sure that the blade is
fully seated against the blade holder.
4. Tighten screws with a screwdriver provided, don’t over-
tighten. (Figure 2)
5. Attach assembled blades and blade holders to the motor
hub using the provided screws & lock washers. (Figure 3)
6. Make sure the screws securing the blade holders to the
motor hub are tight and that the blade holders are properly
seated.
Housing Switch Cup/Adapter Assembly:
7.
Disassemble the Housing Switch Cup/Adapter assembly
by removing three screws. (Figure 4)
8. Assemble the Adapter assembly on the Housing Support
bracket and tighten three screws. (Figure 5)
9. Securely attach the 9-pin switch cup connector to wiring
harness socket within Adapter assembly. (Figure 5)
Figure 3
Fan Blade
Screw
(2 per blade
holder)
Figure 2
Blade
Holder
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
▲ WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
Figure 5
Figure 4
Figure 1