12
How to Operate Your Remote Control (continued)
Figure 4
4.
Pairing Process for Receiver & Transmitter:
(Figure 4)
– The receiver and accompanying transmitter are
matched at the factory. If replacing transmitter or
receiver, you must follow the pairing process below
before using the unit. The fanSync receiver can be
paired to up to five (5) transmitters.
NOTE: Smart device pairing is unlimited.
– After installing the receiver unit, set desired
transmitter code by pushing dip switches (under
battery cover) up or down to the desired positions.
Once code is set, restore power to your fan and press
and hold the fan off button ( ) for approximately 1 to 3
seconds. Fan will turn off, then turn on to medium
speed to indicate that the pairing process is complete.
Please note that you must press the fan off button ( )
within 30 senconds after restoring power. Re-pairing
your device is not necessary after replacing the battery.
Each fanSync receiver can pair to five different
transmitters (with different dip switch codes).
CR2430 3V
21',3
Dip Switch
Dimmer Switch
DIMMER
ON/OFF
NOTE:
Transmitters can pair to multiple receivers, when
performing the pairing process take care not to pair the
transmitter to unintended receivers. It is suggested that
fans more than seven feet apart be on separate power
switches.
Reverse Switch Information
Season
Rotation Direction
Switch Position
Summer
Counter-Clockwise
Left
Winter
Clockwise
Right
5.
If airflow is desired in the opposite direction, turn the
fan off and wait for the blades to stop turning. Slide the
reverse switch on top of motor assembly to the
opposite position and turn fan on again. (Figure 5)
Figure 5
Reverse Switch
