Set Screw
w/Hex Nut
Rubber
Washer (2ea)
Hairpin
Clip
5
How to Assemble Your Ceiling Fan
Figure 1
Pin
Setscrew
Hanger
Ball
Figure 3
Downrod/
Hanger Ball
Assembly
Figure 2
1.
Prior to assembly, set aside and save the hardware
bags packed in the packing. Remove the hanger ball
by loosening the setscrew in the hanger ball until the
ball falls freely down the downrod. Remove the pin
from the downrod, then remove the danger ball.
Retain the pin and hanger ball for reinstallation in
Step5. (Figure1)
2.
The fan comes with blue, black, and white 80”
Separate and untwist the three wires. Route
the wires the wires through the downrod.
NOTE: You will be using either the 4½”
downrod supplied with your fan or an optional downrod
purchased separately.
wires.
Loosen the two setscrews in the downro d support.
Install downrod into coupler. Align the clevis pin
holes in the downrod with the holes in the downrod
support. (Figure 2)
3.
Install the clevis pin, hairpin clip and tighten set
screws. The clevis pin and hair pin clip must be
properly installed to prevent the set screws from
working loose. (Figure 3)
WARNING
It is critical that the clevis screw in the downrod support is
properly installed and the setscrews and nuts are securely
tightened. Failure to verify that the clevis screw, nuts, hairpin
clip and setscrews are properly installed could result in the fan
falling.
▲
Clevis Screw
w/Rubber
Washers (2),
Locknut
