Fanimation Edgewood TF100 Series, Руководство пользователя

Страница: 5 / 14

5
How to Assemble Your Ceiling Fan
1. Prior to assembly, set aside and save the hardware
bags packed in the packing.
2. Remove the Hanger Ball by loosening the setscrew
in the Hanger Ball until the ball falls freely down the
Downrod. (Figure 1) Remove the Pin from the Downrod,
then remove the Hanger Ball. Retain the Pin and Hanger
Ball for reinstallation in Step 7.
3. The fan comes with blue, black, and white 80 ˝ wires.
Separate and untwist the three wires. Route the wires
through the Downrod.
NOTE: You will be using either the 4½ ˝ downrod
supplied with your fan or an optional down rod purchased
separately.
4. Loosen the two setscrews in the Downrod Support.
Install Downrod into Coupler. Align the Clevis Pin holes
in the Downrod with the holes in the Downrod Support.
(Figure 2)
NOTE: The clevis pin and setscrews must be properly
installed as described earlier, or fan-wobble could result.
5. Install the Clevis Pin, Hairpin Clip and tighten Set
Screws. (Figure 2) The Clevis Pin and Hairpin Clip must
be properly installed to prevent the Set Screws from
working loose.
6. Route wires through Canopy Screw Cover and Canopy.
Position Canopy on fan shown with open side facing up.
(Figure 2)
7. Reinstall the Hanger Ball (Figure 2) on the Down rod
as follows. Route the three 80 ˝ wires through the Hanger
Ball. Position the Pin through the two holes in the Down
rod and align the Hanger Ball so the Pin is captured in the
groove in the top of the Hanger Ball. Pull the Hanger Ball
up tight against the pin.
Securely tighten the setscrew
in the Hanger Ball. A loose setscrew could create fan
wobble.
8. The fan comes with blue, black, and white leads. Before
installing fan, measure up approximately 6-9 inches above
top of Downrod/Hanger Ball Assembly. Cut off excess wire
and strip back insulation ½
˝ from each end of wires.
9. You have now completed the assembly of your new
ceiling fan. You can now proceed with the hanging and
the electrical wiring of your fan.
Figure 1
▲ WARNING
It is critical that the clevis screw in the downrod support
is properly installed and the setscrews and nuts are
securely tightened. Failure to verify that the clevis screw,
nuts, hairpin clip and setscrews are properly installed
could result in the fan falling.
Downrod/
Hanger Ball
Assembly
Figure 2
Clevis
Pin
Hairpin
Clip
Ceiling
Canopy
Set Screw (2)
Downrod
Support
Pin
Setscrew
Hanger
Ball
Canopy
Screw Cover