12
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
1.
Position the blade over the blade holder with
threaded posts showing. Make sure the bottom
edge of the blade is fully seated against the blade
arm. With a phillips screwdriver, tighten
3/16
Ý
-24 washer head screws and fiber washers to
secure the blade to the blade arm. (Figure 1)
2.
Remove and discard the motor stops from the
motor assembly by removing the screws.
(Figure 2)
x 15
x 15
FIBER WASHER
3/16
ß
-24
WASHER HEAD
SCREWS
HARDWARE USED:
Blade Holder Arm
Motor
Motor
Stops
Assembly
Blade
Figure 1
Figure 2
Assembling and Mounting the Fan Blades
3.
Secure the blade holders to the motor support
using the 1/4
Ý
-20 screws through the holes located
on the side of the motor support (Figure 3).
NOTE:
Periodically check blade holder hardware and
resecure if necessary.
x 10
1/4
ß
-20
Pan Head Screw
HARDWARE USED:
Figure 3
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in
between the rotating blades.
▲
WARNING
Pan Head Screw
(2 per blade holder)
