Fanelite PRICKLY 38YFT-7057M, Руководство по эксплуатации

Страница: 23 / 26

23
Notes
- A beep is emitted when a function is activated.
- If you intend to not use your ceiling fan for a long time, we advise you to remove the battery
from the remote control to preserve it.
- When changing the direction of rotation of the blades, the ceiling fan must be set to OFF for
the change to take effect (see
Reverse Mode section).
12. REPLACING THE BATTERIES
WARNING : Before replacing the batteries, carefully read the safety instructions in this
manual.
Slide down the battery compartment cover (on the back of the remote control) to open it.
Remove and insert one identical battery with correct polarity. Close the cover by sliding it up.
13. CHANGING THE KIT LED LIGHT/SPEAKER
To change the kit LED light/speaker, please follow the following steps:
1/ Remove the 4 screws.
2/ Disconnect the connectors.
3/ Take the new kit LED light/speaker and install it by connecting its connectors with those of
the ceiling fan, then re-position it correctly and replace the 4 screws.
14. PROBLEMS OF OPERATION
Note : Consult our FAQ section online (www.fanelite.com) for more information.
If your ceiling fan oscillates abnormally when it is working, it may be because the blades are
not well balanced. In this case, use the balancing kit supplied with your ceiling fan to
rebalance them. To identify the defective blade, turn off your ceiling fan, nest one of the small
weights on the edge of a blade and turn on your ceiling fan. Repeat by changing position and
blade if necessary until normal operation of the ceiling fan is resumed. Once the correct
position is found, glue the weight to the blade.
If your ceiling fan no longer works, check the battery status of your remote control. Change
the batteries if necessary and your ceiling fan should re-operate normally. It's possible that
the batteries are not charged enough and only allow to turn on/off the light but not the motor.