1/2
Fancyarn
Bar table
Y84X13
The assembly steps are as follows:
Lay the tabletop facedown on a flat, clean
and non-abrasive surface. As shown
in the diagram below, attach the side
frames to the tabletop and then attach
the stretcher to the side frames. Make
sure you fit the hardware together in the
correct order.
The drawer can
face the front
or the back as
needed.
The steps to change the drawer
orientation are as follows:
1. Pull out the drawer. Then
loosen and remove the
screws with the Allen key.
2. Turn the drawer holder 180 degrees
horizontally. Tighten the screws with the
Allen key and then replace the drawer.
Assembly Instructions
