1-4
3
In order to ensure safety and health for the workers during production process, it is
required to use personal protection equipment (such as gloves, breathing masks
and safety shoes) during operation.
4
Obey the special regulations of accident prevention in the operation manual provided
by FAMSUN.
5
The enterprises are obligated to execute following regulations to ensure operators'
safety.
①
The guard of the coupling must be mounted at any time and kept in place. It is very
dangerous when they are opened or dismantled. It may cause casualty accident.
②
Keep the safety limit switches in good order. Never bypass or discard them.
③
Switch the drive motor off completely to stop the equipment for inspection,
commissioning, repair and maintenance, which can be accomplished through a
full-phase cut-off and lockable switch installed near the equipment or on the
operation desk or the control panel on site. It is not enough only to screw off the
fuse wire!
④
If the equipment needs other energy such as pneumatic, hydraulic, steam or hot
water, it is necessary to cut off the energy supply or turn off the switches, and to
release the pressure in the internal pipeline system of the equipment.
⑤
As for handling heated or cooled parts and components of the equipment, watch for
the danger of burning or scalding as well as frostbiting.
⑥
If you have pressed the emergency-stop switch to shut down the equipment and
you want to reset the switch, it is not permissible to only re-press this button rather
to turn on the main switch to restart the equipment.
⑦
If some equipment is equipped with a partial shutdown system, special care should
be exercised. Read the instruction manuals attached to the equipment carefully. In
such equipment with a partial shutdown system, temperature will rise because
pressure or vacuum will build up if in service for a while.
⑧
Cleaning, lubricating and oiling of the equipment or its parts and components may
go only when the equipment is not in running. If you have to climb on or enter the
equipment to do such work, the following rule shall be mandatory without exception:
cut the motor power supply off completely and lock out the switch with warning tag
attached. Take safety measures for climbing as well.
⑨
Be careful: never do sampling from inside of the equipment unless there is no
danger. Usually, the samples can be taken from the pipe under the equipment
rather than inside of equipment.
⑩
Clean out the deposited dust, dirt and extra materials frequently. Keeping the
equipment clean can enhance production safety and the housekeeping level of
workshop and is also beneficial to prevention of dust explosion.
