Fält Communications 2016 ©
162187 Manual Fältcom ECII® Flex V024D 2016-02-23
Page 26 of 41
6.17 321 – Disconnection of acknowledgement
It is possible to completely disconnect the acknowledgement function. This means that the
Fältcom ECII® Flex will make
only one attempt
to reach the Alarm Receiver 1.
No further
calls will be made, regardless of result, until the alarm button is pushed again.
Each
time any of the buttons 0-9 is pressed on the telephone the disconnect time-out is reset to
180 seconds. Only duplex mode is available.
To disconnect the call simply hang up or press the
button to disconnect the alarm call. If
the call is terminated by hanging up the phone the Fältcom ECII® Flex may stay connected
on the line for up to 3 minutes from the start of the call. E.g. if the conversation lasted for 1
minute the Fältcom ECII® Flex may stay connected for an additional 2 minutes.
The function is activated with:
From keypad:
From phone:
321 #
Return to default acknowledgment:
From keypad:
From phone:
# 321 #
Note: If a speech message is used; press any key to stop the message.
6.18 323 – Acknowledge on end
When the Fältcom ECII® Flex calls out an alarm duplex conversation is automatically con-
nected. But if there is no answer and no tone (0-9) received the Fältcom ECII® Flex will dis-
connect and call next alarm receiver. If Alarm receiver 1 is busy, does not answer or an an-
swering machine answers the call the Fältcom ECII® Flex will call Alarm Receiver 2 and so
on. Each time any of the tones (0-9) is pressed by the receiver the disconnect time-out is re-
set to 180 seconds. Only duplex mode is available.
In order to acknowledge that the call has been received by an authorized person the receiver
must either press a tone during the conversation (0-9) or use the
button to disconnect the
alarm call. The
can be changed to any tone for disconnecting the call, use this if there are
other brands of emergency phones that require a different disconnect command.
The function is activated with:
From keypad:
From phone:
323 #
Return to default acknowledgment:
