4
5)
Remove packaging from front mudguard & fit loosely to the holding
bracket across the front forks. DO NOT TIGHTEN UNTIL WHEEL
IS IN PLACE.
6)
Remove packaging from front brake
assembly. Remove the nut, washer
& 2 spacers from the end of the axle
furthest from the brake lever. Insert
the end of the axle into the wheel
centre so that the brake shoes go
into the brake drum, push the axle
through to come out of the other
side.
Place the 2 spacers onto the axle,
then the washer with the tag facing
inwards followed by the nut with the
serrated edge
inwards. Leave the
nuts at the outer ends of the axle to
make it easier to locate the wheel in
the front forks.
You will need assistance with lifting for this step
7)
Lift up the front forks & place the
axle into the slots on the forks with
the brake assembly on the left hand
side of the bike, making sure the ‘U’
shaped slot on the brake assembly
goes over the locating peg on the left
hand fork leg. The two spacers
should be on the inside of the forks,
there should be a washer on the
outside of the forks on each side with
the tag facing inwards. Put the tag of
each washer into the hole on each fork leg, tighten the two nuts to
leave equal amounts of thread showing on the axle on both sides.
