SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check ap pli ance is safe when you have finished.
36
7 To Remove an Oven element Thermal
Cut-Out.
Disconnect the appliance from the elec tric i ty supply.
Pull the cooker for ward to gain access to the cover
box. Undo the cover screws and lift clear. The
cutout is located on the earth plate be side the oven
element con nec tions. Disconnect the cutout wir ing.
Undo the fi xings that secure the cutout to the earth
plate and re move. Fit re place ment control and re-
as sem ble in reverse order.
8 To Remove a Hotplate Tap
Remove the hotplate – see 2. Unplug the FSD lead
from the rear of the tap. Undo compression fi tting
at the rear of the tap. Remove the fi xings that secure
the tap to the gas rail. Disconnect the ignition switch
wiring. Remove the tap. Remove and discard the
gasket seal. Fit new gasket seal to replacement tap.
Re-assemble in reverse order. Check the appliance is
gas sound. Check hotplate ignition.
9 To Change an Ignition Switch
Change the gas tap - see 7.
10 To Remove a Hotplate Burner Injector
Remove the hotplate - see 2. Remove the injector
directly from the burner body. Fit the appropriate
injector. Re-assemble in reverse order. Check the
appliance is gas sound.
11 To Remove a Hotplate Burner Spark
Electrode
Remove the pan supports, burner heads and caps.
Remove the screw holding the electrode to the
burner body. Lift up the electrode and disconnect
the lead.
Note
Take care to prevent the ignition wire from falling
back through the clearance hole.
Fit the lead to the new electrode and reassemble in
reverse order and check correct burner ignition.
12 To Remove an Oven Door
Open the oven door. Support the door and remove
the two screws that secure the upper hinge to the
front frame of the unit. Remove the door from
the lower hinge by lifting slightly and moving it
outward. Re-assemble in reverse order.
13 To Remove the Oven Outer Door Panel
Open the oven door. Remove the socket headed
screws at the sides of the door. Remove the outer
door panel. Remove the handle and fi t to the new
door panel. Fit the replacement panel to the oven
inner door. Re-assemble in reverse order.
14 To Remove the Door Latch
Remove the oven outer door panel – see 12. Remove
the fi xings that secure the latch assembly to the
inner door panel. Fit the replacement catch and re-
assemble in reverse order. Check correct operation
of door.
15 To Remove the Oven Door Seal
Open the oven door. The seal is held in place by
small hooks on the rear face. At the corner pull seal
diagonally away from the door centre until that hook
is released. Proceed to the next hook and release it
in a similar way, and so on. Use force if the hooks
are stiff, as the old seal will be discarded.
When fi tting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner
holes of the door, and proceed round the door
snapping in each hook in turn.
16 To Adjust the Oven Door Catch Keeper
Open the oven door and slacken the locknut at the
keeper base. Adjust the keeper inward or outward
as required, until the desired door operation is
obtained. Re-tighten the locknut.