SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check ap pli ance is safe when you have finished.
33
Conversion to LP gas
Check in the Technical Data section at
the back of the book that the cooker is
convertible to the gas you want to use.
This conversion must be performed by a
competent person. After conversion the
installation must comply with the relevant
regulations and also the local electricity supply
company requirements. Read the instructions
before converting this appliance.
Failure to convert the appliance correctly could
invalidate any warranty or liability claims and
lead to prosecution.
This instruction must be used in conjunction with
the rest of the appliance in struc tion, in particular
for information on Standards, cooker positioning,
connection hose suitability etc.
When servicing or replacing gas-carrying
components disconnect from gas before
commencing operation and check appliance is gas
sound after completion.
Do not use re-conditioned or unauthorised gas
controls.
Disconnect from the electricity supply before
commencing servicing. Before electrical re-
connection, check that the appliance is electrically
safe.
Jets
Remove burner caps and heads. Remove old jets.
Fit new jets (see the table on the next page for the
correct jets). Reassemble in reverse order.
Tap adjustment
Pull off all the control knobs.
Remove the 3 screws at the rear of the top edge of
the control panel.
Open the oven doors and remove the 2 fi xing
screws, one at each end, underneath the control
panel.
Pull the control panel forward and disconnect the
wiring from the rear.
Remove the shield covering the control taps
(2screws).
A tap bypass screw
Remove the tap bypass screw and replace with the
correct screw. See the table on the next page for the
correct bypass screws.
Set the Govenor
Unscrew the brass top of the governor.
In the base of the brass top is a plastic snap in
converter device.
Natural
gas
Propane
gas
To convert the governor snap the device out of the
top and refi t the other way up. The snap in converter
device is marked to show which gas it is set for.
Make sure the device is secure in the top cap and
refi t the cap to the governor. Stick the appropriate
label on to the data badge to indicate the gas the
appliance is now set for.
Pressure Testing
Connect the appliance to the gas supply. Check the
appliance is gas sound.
The gas pressure can be measured at one of the left
hand hotplate burner jets. Lift off a burner head. Fit
the pressure gauge to the jet. Turn on the hotplate
burner and turn on and light one of the other
burners.
Reassemble burner top, making sure it is
re as sem bled in the correct way on the burner body.