31
INSTALLATION
Check the ap pli ance is electrically safe and gas sound when you have fi nished.
note the maximum cable sizes are 6mm
2
for the screw
terminals and 10mm
2
for the 3 pronged links.
Access to the mains terminal is gained by removing
the electrical terminal cover box on the back panel.
Connect the mains cable to the correct terminals for
your electrical supply type (see fi g.). You may need
to move the links to suit you connection type. Check
that the links are correctly fi tted and that the terminal
screws are tight. Secure the mains cable using the
cable clamp.
This shows the single-phase connection.
These appliances are of type X with regard to
protection against over heating of the surrounding
surfaces.
Fixed Wiring.
For connection to fi xed wiring i.e. fl exible conduit,
remove the electrical terminal cover box on the back
panel. Remove two screws and blanking plate from
the bottom fl ange of the cover box, so as to allow the
conduit through.
Fix conduit to conduit mounting bracket on the back
panel. Connect mains cable to correct terminals for
your electrical supply type. Check that the links are
correctly fi tted and the terminal screws are tight.
Replace electric terminal cover box making sure that
the conduit is clear of the bottom fl ange.
Current Operated Earth Leakage Breakers
Where the installation is protected by a 30 milliamp
sensitivity residual current device (RCD), the combined
use of your cooker and other domestic appliances
may occasionally cause nuisance tripping. In these
instances the cooker circuit may need to be protected
by fi tting 100mA device. This work should be carried
out by a qualifi ed electrician.
Hotplate
Check each burner in turn. There is a fl ame safety
device that stops the fl ow of gas to the burner if the
fl ame goes out. There is also a spark ignition system
that works when the knob is pressed in.
For each burner, push in and turn the knob to the
solid fl ame symbol ( ).
The igniter should spark and light the gas. Keep
hold ing the knob pressed in to let the gas through to
the burner for few seconds. If, when you let go of the
control knob, the burner goes out, the safety device
has not held in. Turn the control to the off position and
wait one minute, then try again this time holding in the
con trol knob for slightly longer.
Turn off the burners.
Oven check
Set the clock to the time of day
When the clock is fi rst connected the display will fl ash (
) and (
) alternately.
To set the clock to read the time of day turn and hold
the Timer knob to the clock symbol
and at the same
time turn the Adjusting knob left or right until the clock
shows the time of day. Remember this is a 24 hour
clock. Let go of the Timer knob and it will spring back to
the vertical
oven manual setting.
Turn on the oven and check that the oven fan starts to
turn and that the oven starts to heat up.
Check that the oven light is working.
NB. The oven light bulb is not included in the
guarantee.
Turn off the oven.