29
INSTALLATION
Check the ap pli ance is electrically safe and gas sound when you have fi nished.
Levelling
You are recommended to use a spirit level on a shelf in
one of the ovens to check for level.
Place the cooker in its intended position taking care not
to twist it within the gap between the kitchen units as
damage may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To
adjust the height of the rear of the cooker use the
levelling tool supplied to turn the adjusting nuts at the
front bottom corners of the cooker.
Adjust the height of the front roller to level the cooker.
Turn clockwise to raise the cooker and anticlockwise to
lower.
When you are satisfi ed with the height and level, raise
the front of the cooker by one turn of the front roller
adjuster. Screw down the front feet to meet the fl oor.
Screw the front roller adjuster anticlockwise to raise the
front roller so that the front of the cooker is supported
on the feet,
not
the front roller, to prevent accidental
movement of the cooker.
Leave the levelling tool in the storage drawer, so
that the customer can use it if they wish to move
the cooker.
Fitting a stability bracket
A stability bracket and chain should be fi tted when the
cooker is connected to a fl exible gas supply.
When fi tting a stability bracket read these instructions
together with the leafl et supplied with the bracket.
1. Place the cooker in its intended position and level
the cooker.
2. Draw a pencil line 100mm from the front edge of
the levelling feet.
3. Mark the centre line for the bracket by measuring
550mm from the left hand side of the cooker.
4. Lower the front roller and move the cooker
forward.
5. Measure back from the pencil line 550mm to locate
the front edge of the bracket. Fix the bracket to the
fl oor.
6. Measure the height from fl oor level to engagement
edge in back of cooker. Add 3mm to this dimension
and assemble the stability bracket to this height.
(i.e. from fl oor level to underside of the top
member) and ensure the bracket does not foul the
oven burner assembly.
Gas Connection
The Gas sup ply needs to terminate with a down facing
bayonet. The rear cover boxes limit the position of the
supply point.
view from the rear
A
position for gas supply connector
B appliance
gas
inlet
Because the height of the cooker can be adjusted
and each connection is different it is diffi cult to give
precise dimensions. Ideally the house supply bayonet
should be in the shaded area shown in the diagram.
Although a 900mm hose can be used, a 1250mm hose
will allow slightly more fl exibility in the positioning
of the bayonet and make moving the cooker easier.
The hose should be fi tted so that both inlet and
outlet connections are vertical so that the hose hangs
downwards.
The connector is located just below the hotplate level
at the rear of the cooker.