22
Australia
Edison screw fi tting 15w 240v lamp, FOR OVENS.
It must be a special bulb, heat resistant to 300 °C.
See the HELP leafl et for spares by mail order.
Open the oven door and remove the Handyrack (if
fi tted) and oven shelves.
Turn off the power supply.
Unscrew the bulb cover by turning anticlockwise.
Unscrew the old bulb. Screw in the new bulb,
screw back the bulb cover. Turn on the electricity
supply and check that the bulb now lights.
Unscrew the old bulb and fi t the new one.
Hotplate ignition or hotplate burners faulty
Is the power on? Is the clock illuminated? If not
there maybe something wrong with the power
supply.
See ‘power supply’ section further on.
Are the sparker (ignition electrode) or burner slots
blocked by debris?
Is the burner trim correctly located?
Are the burner caps correctly located?
See the section entitled ‘Cleaning’
Hotplate burners will not light
Make sure that the burner parts have been
replaced correctly after wiping or removing for
cleaning.
Check that there is not a problem with your gas
supply. You can do this by making sure that other
gas appliances you may have are working.
Do the burners spark when you push the
button? If not check the power is on - is the clock
illuminated?
This appliance must be installed by a Authorised
Person in accordance with the installation
instructions. The installation must comply with
the relevant regulations and also the local gas
and electricity supply companies requirements.
General Safety Instructions
If you smell gas
Don’t
turn electric switches on or off.
Don’t
smoke
Don’t
use naked fl ames
Do
turn off the gas at the meter or cylinder
Do
open doors and windows to get rid of the gas
Call
your gas supplier.
Guidelines in case of Abnormal Operation
The burners fl ames should be a blueish colour
with, at most, a slight yellowish fringe.
If the fl ame burns with a long white tip you
should call an Authorised Gas Service Centre.
DO NOT SPRAY AEROSOLS IN THE VICINITY OF
THIS APPLIANCE WHILE IT IS IN OPERATION.
WHERE THIS APPLIANCE IS INSTALLED IN
MARINE CRAFT OR IN CARAVANS, IT SHALL NOT
BE USED AS A SPACE HEATER.
This appliance is designed for domestic
cooking only. Use for any other purpose
could invalidate any warranty or liability
claim.
The use of a gas cooking appliance results in the
production of heat and moisture in the room in
which it is in stalled. Ensure that the kitchen is
well ventilated: keep nat u ral ven ti la tion holes
open or install a mechanical ventilation device,
(mechanical extractor hood).
Prolonged intensive use of the appliance may
call for additional ventilation, for ex am ple
opening a window, or more effective ventilation,
for example in creas ing the lev el of mechanical
ventilation where present.
The cooker should be serviced by a qualifi ed
service engineer and only approved spare parts
used. Have the installer show you the location
of the cooker control switch. Mark it for easy
reference. Always allow the cooker to cool and
then switch off at the mains and before cleaning
or carrying out any maintenance work, unless
specifi ed otherwise in this guide.
All parts of the cooker become hot with use
and will retain heat even after you have
stopped cooking.
Take care when touching cooker, to minimize the
possibility of burns, always be certain that the
controls are in the OFF position and that it is cool
before attempting to clean the cooker.