Falcon E3840, Инструкция по установке, обслуживанию и эксплуатации, Страница: 17 / 37

13
Note
Remember to check for oil leaks before replacing any panels.
TEMPERATURE LIMIT (safety)THERMOSTAT
a) Remove element box lid
b) Undo phial retention nut.
c) Lift elements and secure in raised position.
d) Release phial from retaining clip.
e) Disconnect phial wire plug and cut off plug.
f) Pull down phial to remove.
g) Carefully replace in reverse order. Check for any oil leaks and that thermostat calibration
is within specification.
3.8
CONTACTORS & FILTRATION PUMP TIMER
a) Remove six fixings from rear control compartment cover.
b) Disconnect wiring from faulty component, noting all connections.
c) Replace and rewire component.
d) Replace cover.
3.9
OIL LEVEL SENSOR
(E3840X & E3840FX only, Figure 6)
a) Ensure fry pot is empty
b) Remove back panel.
c) Disconnect oil sensor wires (blue & red BNC connectors) from the evaluation unit.
d) Remove RH side panel.
e) Remove element box lid
f) Carefully feed oil sensor wires (blue & red BNC connectors) up through element box
legs into the element box.
g) Undo oil level sensor retaining nuts
h) Pull the oil level sensor down into the pan and carefully feed the wires through the boss.
i) Carefully replace in reverse order.
Note
In the extraordinary event that the oil level sensor does come into contact
with fire. The probe should be replaced.
3.10
TOP UP AND LOW OIL LEVEL LEDS
(E3840X & E3840FX only, Figure 6)
a) Remove control panel by undoing fixings at top and bottom of control panel. Disconnect control
panel.
b) Remove electrical connections from LEDs. Undo LED retention nut.
c) Carefully replace in reverse order.