Falcon Classic Deluxe 90 Dual Fuel, Руководство пользователя и инструкции по установке, Страница: 38 / 44

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas supplies before servicing. Check appliance is safe when you have finished.
36
6 Doors
6.1 To Remove the Grill Door
Remove the left-hand side panel (see 1.3). Remove
the plinth (4 screws) and the central vertical cover
(5 screws). Remove the 2 countersunk screws (1 each
side) securing the grill hinge arms to the front of the
grill chamber.
Note: The arms are spring tensioned. Carefully remove
the grill door. Retain the gaskets.
Reassemble in the reverse order, making sure that the
gasket is fitted between the hinge arm and the front of
the grill chamber.
6.2 To Replace the Main Oven Door
Open the oven door. Support the door and loosen the
2 screws securing the upper hinge and gasket to the
cooker front (Fig.9-9) .
n n
The door is heavy, so take care.
Support the door and remove the screw nearest the
hinge pin
(Fig.9-10)
. Swing the hinge up and away from
the door hinge pin. Lift the door away from the lower
hinge and remove.
Reassemble in reverse order.
6.3 To Adjust the Main Oven Door Angle
The bottom hinge of either oven door can be adjusted
to alter the angle of the door
(Fig.9-11)
. Loosen the
bottom hinge fixing screws and use the notch and a flat
bladed screwdriver to move the position of the hinge to
set the hinge position
(Fig.9-12)
.
Retighten the hinge screws.
6.4 To Replace the Main Oven Door Outer Panel
Move the cooker forwards to gain access to the sides.
Open the oven door slightly and remove the 4 front
panel fixing screws from the door sides (2 each side),
(Fig.9-13)
. Carefully lift off the outer door panel.
Remove the door handle from the panel by unscrewing
the 2 retaining nuts.
Fit the door handle to the new panel.
Fit the panel to the door. Reassemble in reverse order.
6.5 To Change the Main Left Hand Oven Door Latch
Remove the main oven door outer panel (see 6.4).
Remove screws ‘B’, which hold the latch assembly to
the inner door panel
(Fig.9-14)
. Fit the new catch and
reassemble in reverse order. Check the door operation.
6.6 To Adjust the Main Left Hand Oven Door Catch
Keep
Open the oven door, slacken off the locknut at the base
of the keep, and screw in or out as required until the
required fit is obtained. Retighten the locking nut
(Fig.9-15) .
ArtNo.320-0002c
- Oven door side screws (Elan)
Fig.9-13
ArtNo.320-0003 Oven door latch
B
Fig.9-14
ArtNo.320-0004 Oven door keep
Fig.9-15
ArtNo.320-0006 Oven door hinge adjustment 1
Fig.9-12
Effect of hinge adjustment – exagerrated for clarity
ArtNo.320-0001 Door hinges
1
ArtNo.320-0001 Door hinges
2
Fig.9-9 Fig.9-10
ArtNo.320-0007 Oven door hinge adjustment 2
Fig.9-11
Centreline of hinge pin
Oven door omitted for clarity