INSTALLATION
Check the appliance is electrically safe when you have finished.
20
Adjust the height of the front roller to level the cooker. Turn
clockwise to raise the cooker and anticlockwise to lower.
When you are satisfied with the height and level, raise the
front of the cooker by one turn of the front roller adjuster.
Screw down the front feet to meet the floor. Screw the front
roller adjuster anticlockwise to raise the front roller so that
the front of the cooker is supported on the feet, not the front
roller, to prevent accidental movement of the cooker.
Leave the levelling tool on the adjuster with the handle of the
tool facing the rear of the cooker, so that the customer can
use it if they wish to move the cooker.
Replace the drawer by locating it on the side runners and
pushing in.
Fitting the Handles
To fit the handles, first remove the 4mm Allen screws from
the doors. Locate the door handles to the doors, making sure
that the handles are above the fittings, and secure in position
using the Allen screws.
The fit the front handrail, first remove the 4mm Allen screws
from the top corners of the fascia. Locate the handrail to the
fascia and secure in place.
Fitting the Splashback (optional)
The splashback fits the back of the cooker. It is secured using
4 screws (2 at each end) in the rear edge of the flue grille.
Remove the outer 2 screws and then loosen the inner pair. Fit
the splashback over the inner screws and then refit the outer
screws
(Fig.6-11)
. Tighten all screws to secure.
Electrical Connection
The cooker must be installed by a qualified electrician, in
accordance with all relevant British Standards/Codes of
Practice (in particular BS 7671), or with the relevant national
and local regulations.
WARNING: THE APPLIANCE MUST BE EARTHED.
Note:
The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker, through
a suitable cooker control unit incorporating a double pole
switch, having a contact separation of at least 3mm in all
poles.
The cooker must not be connected to an ordinary
domestic power point.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect
the mains cable to the correct terminals for your electrical
supply type (
Fig.6-12
and
Fig.6-13
). Check that the links are
correctly fitted and that the terminal screws are tight. Secure
the mains cable using the cable clamp.
Hob Check
Check each cooking zone in turn. Be sure to use pans of the
correct size and material.
ArtNo.130-0010 Electrical connections single-phase
�
�
������������
�����
���
ArtNo.130-0010 Electrical connections 3-phase
��
�
��
��
�����
�������������
����
���
�����
���
Fig.6-12
Fig.6-13
ArtNo.421-0001 - Fitting a splashback Classic
Fig.6-11
