2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of Can Am Maverick X3
Full Polycarbonate Windshield
CA-X3-WD02 / 50-40054
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you
are happy with the product before removing protective film. Once the film is removed you cannot return
the product for a full refund.
Be sure to read these instructions thoroughly before opening and installing the Can-Am Full Polycarbonate Windshield.
1.
Check over the parts included in the cartons with the parts list shown below:
2” Loom Clamps
6 each
1 1/2” Loom Clamps
2 each
1” Stainless Steels Bolts
8 each
Small SS Washers
8 each
Plastic Thumb Nuts
8 each
Large SS Washers
8 each
Large Rubber Washers
8 each
2” Adhesive Rubber Strips
6 each
56” Small Side Bulb Gasket
1 each
3” Velcro Tabs
2 each
3” Adhesive Hook Strips
2 each
Polycarbonate Windshield
1 each
If any parts are damaged or missing please contact customer service at (606) 845-7439.
2.
Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Begin by peeling off the
protective film. Next take the 56” piece of rubber gasket and starting at one end firmly place across the bottom of the
windshield. You may need to trim off excess gasket. The diagram below show where to install the gasket.
3.
Now the Windshield is ready to be installed. With the help of a friend, place the Windshield on the X3, setting it
up onto the hood.
