FALCOM MAMBOII, Руководство пользователя

Страница: 165 / 271

C
ONFIGURATION
C
OMMAND
S
ET
- F
IRMWARE
R
EVISION
2.4.0_
BETA
- V
ERSION
1.0.0
1
Periodically requests the status of the digital inputs
operation. How often a report is requested depends on
the specified time
<in_inval>.
2
Requests reports, only when any digital input changes its
state.
< in_inval >
Indicates, in seconds (in hex) , how often to request the status of the digital input
from the I/O-BOX (only if
< in_report_mode >= 1 )
.
It can be set to a value from
0x 01 to 0x FF.
< ana_report_mode >
It defines the mode for requesting the status of the analog inputs operation. It
can be set to:
Value Meaning
0
No status request.
1
Periodically requests the status of the analog inputs
operation. How often a report is requested depends on
the user-specified time on the
<ana_inval>.
2
Requests reports, only when the value <ana_inval> and
current delta value on any analog input results different.
< ana_inval >
This value depends on the configuration of the
<ana_report_mode>:
If < ana_report_mode >= 1 ,
it defines, in seconds (in hex), how often to
request the status of the analog inputs from the I/O-BOX. In this case it
can be set to a value from 0x
01
to 0x
FF.
If < ana_report_mode >= 2 ,
it specifies a delta value, which will be
compared to the current delta value on the analog inputs .
< address >
Defines the address that identifies your I/O-BOX. Enter all 16-digits derived from
the MAC address of the I/O-BOX.
The MAC address is given on a sticker on the back of the I/O-BOX unit named
“MIEEE: ....”. Each I/O-BOX unit has an unique MAC address.
Figure 5: Shows the location of the I/O-BOX's MAC address
How to set/get IO configuration:
Set configuration
$PFAL,CNF.Set,IEEE.IOBOX0=0,2,0,2,F,0017920030000DA8
Get configuration $PFAL,Cnf.Get,IEEE.IOBOX2
Notes
•
To delete/remove an existing device, set the MAC address to zero, for
example:
PFAL,cnf.set,IEEE.IOBOX2=0,0,0,0,0,0000000000000000.
•
Disable and Enable IEEE chip inside manually (using
PFAL,Sys.IEEE.
[Disable,Enable] accordingly) after your IEEE-specified
configuration completes
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
Page 165 of 271