Falco FAL70GW, Инструкция по эксплуатации

Страница: 12 / 12

11
IMPORTANT: IDEALLY YOU SHOULD SWITCH ON YOUR
HOOD TEN MINUTES BEFORE YOU START TO COOK, OR AT
THE VERY LEAST WHEN YOU BEGIN COOKING. YOU
SHOULD ALSO RUN YOUR HOOD FOR TEN MINUTES AFTER
YOU HAVE FINISHED COOKING.
The cooker hood lights
o
The two LED lights can be switched on and off by pressing the
light control button.
o
Press the ambient light button to switch on the coloured LED
ambient light. Each press of this button will change the colour
of ambient light.
o
If you press and hold the ambient light button for about 3
seconds, the light will cycle through the various colours
automatically.
o
When the ambient light is showing the desired colour, you can
press the ambient light button once to set the current colour
manually again.
IMPORTANT: The lights should only be turned on when the cooker hood is in use.
The lights should not be used as a separate light source for the room.
MAINTENANCE
The cleaning of the carbon grease filter mesh
The filter mesh is made of high-density stainless steel. Please do not
use the corrosive detergent on it. Keeping this filter clean will keep
the appliance running correctly. Please strictly follow the guidelines
below.
Method 1: Put the mesh into 40-50 c clean water, pour on detergent,
and soak for 2-3 mins. Wear gloves and clean with a soft brush.
Please do not apply too much pressure, as the mesh is delicate and
will damage easy.
Method 2: If instructed to do so, it can be put into a dishwasher, set
the temperature at around 60 degrees.
Note:Pls make sure power off when you are going to clean the hood.