2
Please be careful when removing and installing the Island installation Brackets and Stainless
Steel chimneys. The Stain Less steel chimneys contains sharp edges and can possibly lead
to cuts.
Generally asked Questions and Answers:
1. Q: My extractor fan is not extracting
A:
before logging a service call please ensure the installation on your extractor fans was
done properly to avoid a service call out fee charge. Herewith a list of commonly found
mistakes on everyday installations:
* Installer did not remove the tape on the butterfly valve. (Q: 13).
*
Installer did not secure the power cord inside the chimney. (Q: 13).
*
Your ducting hose is exceeding the recommended maximum length. (Q: 13).
*
Your unit is not at the recommended height. (Q: 3).
*
Your
unit
is
installed
above
the
wrong
application.
(Q:
2).
R 450.00 Service fee will apply when we log a service call and any of the points above apply.
2. Q: Can I use the extractor fan above my gas braai?
A:
NO. Please note that this unit was designed for the intended purpose of domestic
kitchens only and cannot be used as a commercial extractor fan. Commercial usage
includes but is not limited to: Restaurants, Coffee Shops, Soup Kitchens, Tuck shops, Food
trailers, Gas braai’s inside or outside your property, any other form of braai and any kitchen
that is used for commercial purposes. Using the extractor you purchased on any commercial
application poses a serious fire risk and will result in immediate void of your warranty. Please
contact our Falco offices for assistance with Gas Braai Extractors.
3. Q: What is the correct installation height?
A:
The recommended installation height is 750mm above gas and 650mm above electrical.
On either application it is recommended that your installation height does not exceed 750mm
to ensure the best results.
Q: Do I require a recirculation kit?
A:
No. The extractor was designed to be used on both applications; External and Re-
circulation air operation and no additional kit are required.
4. Q: What is the difference between External and Re-circulation air operation?
A: Re- circulation;
All wall mount units are supplied with aluminium and charcoal filters. For
Re-circulation mode you will simply install the unit. The air will filtrate through both sets of
filters, you’re outside aluminium filters
and
you’re inside charcoal filters.The air discharged
from your extractor is then clean and crease free and cannot cause any damage. There are
two options when using your extractor on Re-circulation. 1 – Let the filtrated air escape
through the vents on top of your top chimney or you can use the extendable ducting house
to vent the air into your ceiling.
in the charcoal filters removes odour
and smoke particles from the air before releasing the cleaned air back into the kitchen.
External:
The only difference between Re-circulation mode and external mode is that on
external mode you are venting the air to the outside of your property using a ducting hose.
This means the clean filtrated air will not be discharged into your kitchen or ceiling but to the
outside. The unit is supplied with an extendable ducting hose. When venting your air
outwards the charcoal filters can be removed to improve the suction rate. Removing the
charcoal filters on re-circulation mode is not recommended.