Fairford synergy, Руководство пользователя

Страница: 34 / 233

Synergy Series Soft Start User Manual
MAN-SGY-017. Version 01. 27/06/2016
34
3.1 Status LED
The Fairford logo LED on the synergy front panel will blink once every 10 seconds to
provide visual confirmation that all microprocessors in the soft starter are operating
properly.
3.2 Configuration Overview
Configuring synergy soft starters is as simple as setting the parameters to match your motor, application,
power source, control scheme, etc.
You can configure synergy from its touchscreen, from an optional remote touchscreen, or from a
PLC using Modbus RTU via the onboard RJ12 connector.
3.2.1 Auto Setup Procedure
Allow the user to change all of the parameters at once to settings that are typical for general applications.
One or more parameters as can be adjusted to fine tune the settings for your specific application.
3.2.2 Setup by Individual Parameter Settings
Allows the user to change the parameter settings one at a time.The individual parameters are grouped by
categories as on the touchscreen.
3.3 Configuration From Touchscreen
Use the the on-screen buttons to enter data or to scroll through setup menus, using
the “Up,” Dn,” “BACK,” and “NEXT” buttons as necessary. From the home “Menu”
screen, select either “Auto Setup” or “Advanced.”
3.3.1 Auto Setup
On initial power up, synergy will show a ‘Setup Wizard’ menu – Auto and Advanced. To jump immediately to
the pre-defined parameter sets, press the Auto button and follow the on-screen prompts. Refer to the
example on the following screen.
To automatically set up parameters on subsequent start-up, select the ‘Home’ menu from the status screen
and select ‘Auto Setup’. Follow the on-screen prompts. Refer to the example on the following screen.
3.3.2 Individual Parameter Setup
From the Setup Wizard or Home menu, select the ‘Advanced’ menu. Set the required parameters from the
displayed menus. See Section 3.8 for detailed descriptions of the available parameters.
Chapter
3
3. Configuration and Parameters