Fagor CO-500, Руководство по обслуживанию

Страница: 34 / 124

22/07/2019
33
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
At the end of the day, the machine must be cleaned. Follow the instructions given in this manual with respect to
cleaning.
9.3.6. SELF-CLEANING CYCLE:
It is also possible to use the Self-cleaning option, which in addition to draining the tub, runs an internal cleaning
cycle. Without removing the filters and with the door closed, press SC , and SELF-CLEANING is displayed. Next
press START to start the cycle. After several minutes, the cycle ends and a message is displayed together with a
buzzer alarm and the machine automatically switches off.
The Self-cleaning cycle does not replace the need for a more exhaustive manual clean as necessary.
9.4. OPERATION OF THE CONCEPT
The wash cycle of the machine includes a wash, drainage and a final rinse.
The tank thermostat maintains the wash water temperature and a motor pump sends this water with detergent to
the washing arms. The jets of water reach the dishes from different directions in order to guarantee a uniform
wash.
Between the wash cycle and the rinse cycle there is a pause of a few seconds to allow the detergent to drain off the
dishes into the wash tub. If the machine has a drainage pump, part of the water is drained from the tank and
replaced by clean rinsing water.
Lastly, the dishes are rinsed with mains water heated to between 80 ºC - 85 ºC / 76 ºF - 85
⁰
F to remove the detergent
from the dishes and at the same time regenerate the water in the wash tank, making it less dirty.
To start the wash process in the models with Cycle SELECTOR switch, turn the switch to the required cycle P1 , P2 ,
P3 , CONTINUOUS WASH , insert the basket with the dishes in the machine and close the hood. The CYCLE Led
lights up while the cycle is running.
If the machine does NOT have a Cycle SELECTOR switch, just press the button corresponding to the required cycle
P1 , P2 , P3 , insert the basket with the dishes in the machine and close the hood. The Led L1 , L2 or L3 corresponding
to the selected cycle flashes while the cycle is running. For the CONTINUOUS WASH cycle, press and hold P3 for
more than 3 seconds with the hood closed; to stop the continuous wash cycle, press and hold P3 again for more
than 3 seconds with the hood closed.
The cycle selected will remain selected until the selection is changed or the appliance is switched off.
Selecting the wash cycle:
C1 -
Medium
C2 - Largo
CO-500 120s 180s
C1 - Short C2 - Medium C3 - Long
CO-501 90s 120s 180s
P1 - Short P2 - Medium P3 - Long PG - Glass
CO-502 90s 120s 180s -
Tank temp. 55 - 65 ºC / 131 - 149
⁰
F
Boiler temp. 80 - 85 ºC / 176 - 185
⁰
F
65 ºC / 149
ºF
The cycle should be selected according to the dirt on the dishes:
Short cycle (for dishes which are not very dirty).