Fagor CO-500, Руководство по обслуживанию

Страница: 23 / 124

22/07/2019
22
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
8.4.2. RINSE AID ELECTRIC DISPENSER CONNECTION (CONCEPT PLUS and ADVANCE)
INSTALLATION
The electric rinse aid dispenser is pre-installed in the appliance. First, the end of the blue tube with filter located at
the back of your machine and marked “Rinse Aid” must be inserted inside the rinse container.
The tubes are see-through to allow you to check that the chemicals are correctly dispensed.
To access the dispensers and adjust them, remove the lower front cover of the appliance.
OPERATION
This dispenser absorbs and dispenses the rinse aid when the rinse pump is switched on. That is, when the machine
is filling and during the rinse cycle.
LOADING PROCESS
When the appliance is switched on, the loading process takes place automatically while the machine is filling.
ADJUSTING THE DOSE
The dispenser should be adjusted when the machine is installed to ensure that the wash is optimised from the
start. The setting should be adjusted according to the type of rinse aid and the water hardness. Turn the
adjustment screw until the required dose is obtained (turn clockwise to increase and anticlockwise to reduce the
dose).
Position 1 1.5 2 2.5 3 3.5 4 4.5 5
Dose (l/h) 0.14 0.21 0.28 0.35 0.42 0.49 0.56 0.63 0.7
Dose during
rinse cycle
(ml, cc)
0.4 0.6 0.8 1 1.2 1.4 1.6 1.8 2
Electrical
connection
(rear section)
Rinse Aid
Filter
Rinse
line
Regulation