Fagor CNC 8070, Конфигурация оборудования

Страница: 172 / 276

Hardware configuration.
CNC 8070
7.
CENTRAL U
N
IT
FOR C
ABI
NET (Q7-A
PLATFORM).
Conn
ecti
ons.
·172·
(R
EF
: 1911)
7.8.10 CAN bus.
CANopen is a network communication protocol based on the CAN bus system for connecting
the CNC with remote modules and keyboards. The CAN connection supports up to 32
devices (nodes), including the central unit; more one than keyboard and several groups of
remote modules are possible.
CAN connector.
The cable shield must be connected to the connector at both ends. The connector has two
shield pins. Both pins are equivalent; the CAN shield may be connected to either one.
Characteristics of the CAN cable.
Use a specific CAN cable. The ends of all the wires and the shield must be protected by the
corresponding terminal (pin). Also use the terminals (pins) to secure the cable to the
connector.
Bus CAN with CNC (master) and RIOR nodes.
Characteristic. Description.
Type. Shielded. Twisted pair (1 x 2 x 0.22 mm²).
Flexibility. Extremely flexible. Minimum bending radius, static = 50 mm and
dynamic = 95 mm.
Cover. PUR
Impedance. Cat.5 (100

- 120

)
Master
Node 1 Node 2
CAN bus.
B28 B28A B28B B28A B28B
Node n
Plug-in part. 5-pole Phoenix-contact minicombicon connector (3.5 mm
pitch).
Pin. Signal. Function.
1 GND Ground / 0 V.
2 CL (LOW) bus signal.
3 SH CAN shield.
4 CH (HIGH) bus signal.
5 SH CAN shield.