Fagor CNC 8058elite T, Руководство пользователя

Страница: 63 / 90

CNCelite
8058 8060
8065
4
ꞏ63ꞏ
R
EF
. 2106
4.
CANNED CYCLES. CYCLE
EDITOR.
The cycles may be defined anywhere in the program, that is, in the main program as well
as in a subroutine.
Programming the cycles of the editor.
The cycles of the editor are accessed with the following softkeys:
Probing canned cycles are not modal; therefore, they must be programmed every time any
of them is to be executed. The execution of these cycles does not change the program
history.
Cycle data programming.
The cycle number and the rest of parameters may be defined with a number, an arithmetic
parameter or expression whose result is a number. See
"4.1 How to define the data of the
editor." on page 64.
Limitations for executing the cycles.
These cycles cannot be executed if tool radius compensation is active.
Canned cycles and the work planes.
A canned cycle may be defined anywhere in the program, that is, in the main program as
well as in a subroutine. When working in a plane other than the ZX, the CNC interprets the
canned cycle parameters as follows:
Using the configuration softkey, the user can select the graphics for
vertical lathes. By default, it will show the graphics for horizontal lathes.
Tool calibration.
Tabletop probe calibration.
Part measurement along the ordinate axis.
Part measurement along the abscissa axis.
Parameter Z-X plane W-X plane A-B plane
Parameter Z and all related to it, with the abscissa
axis Z axis W axis A axis
Parameter X and all related to it, with the ordinate
axis X axis X axis B axis