fafnir UM-X, Техническая документация инструкция, Страница: 5 / 35

UM-X
Page 5/35
2 Safety instructions
The UM-X measurement analysis system is used as a standalone filling level
display for continuous filling level sensors. Please only use the system for this
purpose. The manufacturer accepts no liability for any damage resulting from
other uses!
The UM-X measurement analysis system has been developed, manufactured and
inspected in accordance with state-of-the-art technology and with recognised
technical safety rules and regulations. Nevertheless, hazards may arise from its
use. Therefore, please observe the following safety instructions:
• Do not make any changes, add anything to or rebuild the system without
obtaining the manufacturer’s permission first.
• All installation and maintenance work, with the exception of the function test,
must only be carried out when the power supply is disconnected.
• The measuring transducer must be installed outside a potentially explosive
zone.
• Installation, operation, and maintenance of the UM-X measurement analysis
system must only be performed by competent personnel. Specialised knowledge
must be obtained by undergoing regular training.
• Operators, setting up and maintenance personnel must observe all the
applicable safety regulations. This also applies to the local safety and accident
prevention regulations not mentioned in these operating instructions.
The safety instructions in this manual are identified as follows:
If you do not observe these safety instructions, there is a risk of an
accident or the measurement analysis system can be damaged.
Useful information that will guarantee proper function of the system
or facilitate your work.
2.1 Password
You need a password for some menu items in order to be able to launch
the items or make changes.
The password will be provided on an accompanying sheet and must
only be used by instructed persons.