FaderMate Master Control Unit, Руководство по фитингам

Страница: 31 / 36

4.8 Connecting Console Audio to the FCU
NOTE: Only perform this step if you are actually installing the system in a console.
If you are performing a ‘dry run’ to ensure that the system is working correctly, skip
this step.
Console audio is connected to the relevant FCU by means of the connectors labelled ‘ AFn ‘
(where n can be any number between 1 and 8 [inclusive]). Figure 4.8.1 illustrates the
positions of these connectors on the FCU board.
Figure 4.8.1 - FCU Audio Connector Positions
As shown in Figure 4.8.1, the signals from top to bottom are ‘Ground’, ‘Wiper’ and ‘Top’.
The audio cables which have been removed from the existing faders in the console should
be soldered to the appropriate AFn pads on the FCU board.
31