Facom CL2.BA19 809184, Инструкция по эксплуатации

Страница: 7 / 34

7
V
When you plug the charger, the green indicator
blinks.
The charger is waiting as the
battery temperature is not
adapted to the charge, the
red indicator blinks.
If the 2 indicators lit :
- the battery either does not comply or is faulty,
- or the charger is faulty.
Contact your retailer
The battery is charged properly.
The green
indicator is lit.
Push the battery fully onto the charger by sliding it in the direction
shown by the arrow.
The battery is charging,
the red indicator is lit.
1
3
2
Charging the batteries:
Your new batteries will reach their full capacity only after about 3 ‘’charge-discharge ‘’ cycles.
Charging the battery:
- Press the release button (mark V)
on the battery to release it from the machine.
- Slide the battery to the front of the machine.
- Connect the charger to mains (100 - 240 V
AC
).
Disconnect the charger.
- Slide it to pull the battery out from the charger.
- Re-engage the battery firmly onto the machine.
Charger :
- Your charger can be sued to charge FACOM batteries, 19.2 Volts Li-Ion only.
Charging conditions:
- To ensure the best possible charge, the battery charger has a temperature sensor (NTC) authorising charging between
0˚C and 45˚C.
- If the battery has been stored at a temperature below 0˚C, allow it to warm up to room temperature before charging it.
- If a battery is too hot after prolonged use, allow it to cool down for a few minutes before charging it.