FabWeaver A530, Руководство пользователя

Страница: 63 / 120

2
-25
UI Menu Description
2
1) Press the
[Start]
button to print the calibration pattern. There are 4 prints as shown in the figure below.
2) As shown in the figure below, measure the height including the raft shape using a measuring tool such as a
vernier caliper at the center of the printout.
- Measure each part printed from “Nozzle 1” and find the average value of 4 values.
- Measure each part printed from “Nozzle 2” and find the average value of 4 values.
.
Important
- The part printed from “Nozzle 1” is distinguishable because it has a longer shape than the part printed
from “Nozzle 2”.
3) On the UI screen, input the average values of Nozzle 1 and Nozzle 2 to “Nozzle 1” and “Nozzle 2”,
respectively, and press the [Save] button.
Important
- If the average value is within ±0.05 mm of the reference value of 5 mm, no further adjustment is required
and no value entry is required.
Nozzle1 Nozzle2
Nozzle1 Nozzle2
Note
- You can touch the number of the input field to enter the value directly, or touch the [-] or [+] buttons to adjust the
value you want to input.
- The additional calibration value that you saved is accumulated in the previously stored value and reflected in the
output. The final value reflected in the printer is displayed at the bottom left.
- If you are performing auto-calibration again, the existing additional compensation value is initialized.
3 If you want to reset the incorrectly entered value or initialize additional calibration values, you can press the
[ Reset Offsets] button in the upper right corner.
Test Print
The example files saved in the printer can be printed.