FabWeaver A530, Руководство пользователя

Страница: 18 / 120

Before using the Machine
10
7. Ventilation
Caution
- Use this product in a well-ventilated place.
- Do NOT block vents for heat dissipation of the product. If the heat dissipation is blocked,
the internal temperature of this product may increase and cause malfunctions.
- In general, the product generate some gaseous substances.
Thus, when the product is first used, pay attention to the ventilation in
workplace where the product is located. If much works should be done, it is
recommended not to stay in the place for as far as possible.
- It is recommended to expand the supply and exhaust facilities or install a ventilation device such as a
fan at the 3D printer installation site.
- The following method is recommended for indoor ventilation.
Indoor ventilation
(Ventilation device)
1. Consider the indoor space and use an indoor fan with an appropriate capacity.
2. Turn on the fan before operating the 3D printer and run the fan for at least 1 hour after
using the 3D printer.
3. Do not completely close the door while the fan is running but leave it slightly open.
4. Use of a fan should be combined with natural ventilation
Indoor ventilation
(Natural ventilation)
1. In spring and autumn, open windows 5 to 20 cm apart to allow for outside air.
2. In summer and winter, open windows and doors for about 5 minutes immediately after
3D printer operation, and ventilation is required for at least 5 minutes every hour.
3. After using the 3D printer open the printer door to ventilate for at least 30 minutes.
▶
Depending on the surrounding environment and atmospheric conditions, consider
whether or not polluted external air is introduced into the room to provide natural
ventilation.
- It is recommended to wear an industrial dust mask when operating a 3D printer.