Faber Vaska, Руководство по установке, Страница: 9 / 24

Installation manual Vaska
8 < < < <
See fig. 1.2b for the wiring diagram with I.T.C.
(optional):
A = Adapter (6V)
B = Gas valve
C = Receiver
D = Ignition pin
E = I.T.C. (Intelligent Technical Controller)
4.3 Smart Home installation

Please note
This is only possible if the fire is equipped
with I.T.C!
The controller can be connected to an external
source, such as a Domotica system, by using a
Faber Interface Unit (article number A9323000).
4.4 Preparing the fireplace

Remove the fireplace from its packaging.

Remove the packaged parts from the
fireplace, see section 4.5.

Prepare the gas connection on the gas
valve.
4.5 Opening the door
The door handle is equipped with a locking screw,
which must be loosened before the door can be
opened, see fig. 1.3a. Now pull the door handle to
open the door, see fig. 1.3b and 1.3c.

Please note
After closing the door, always fasten the
locking screw again! This ensures that the
appliance can’t be opened by vulnerable
persons.
4.6 Positioning the fireplace
Take into account the installation requirements
(see chapter 3). Place the fireplace at the right
place. There is no height adjustment at the
appliance.
4.7 Installing the flue pipes
Install the flue pipes according to the installation
manual supplied with the appliance (40011968)!

The distance to combustible materials
must be min. 50mm, calculated from the
outside of the flue pipe.

Never start immediately with an
adjustable flue pipe on the appliance.

Horizontal sections should be installed to
allow a slope towards the appliance
(3 degrees).

Built the system from the appliance. If this
is not possible you can make use of an
adjustable flue pipe.

For fitting of the flue system, the 0,5m
length-adjustable pipe must be used.
Make sure that the inner pipe is always
15mm longer than the outer pipe. Wall-
and roof terminal can also be cut. These
components must be secured with a self-
tapping screw.
5 Removing glass (from the inside)

Open the door, see section 4.5.

Disassemble the glass strips by removing
the 8 bolts, see fig. 1.4.

Carefully remove the front glass.
For replacing the glass repeat the steps in reverse
order.

Please note!
Avoid fingerprints on the glass, these are no
longer removable once the fire is used.
6 Placing decoration material
It is not permitted to use other or to add more
material in the combustion chamber.
See the supplied decoration instruction card or
chapter 18:

Place the log set. Make sure that the logs
are properly connected to the tube
burners and rest on the burner plate.

Divide the ash material between the logs.

Please note!
Keep the pilot flame free from ash material.

Start the fireplace as described in the user
manual.

Assess whether the flame distribution is
good. Move or remove any ash material to
create a nice glow bed.

Close the door, fasten the locking screw
(fig. 1.3a) and check the fire image.
7 Checking the installation
Checking for gas leaks
Check with a gas leak finder all connections and
pipes for gas leakage.
Check inlet- and burner pressure
Check if the inlet pressure correspond to the data
on the rating plate.