Faber theMOOD, Инструкция по установке и руководство пользователя, Страница: 9 / 16

8 < < < <
L
Ordered separately and included:
Box with exhaust pipe.
5 Installation requirements
5.1 Installation of theMOOD
Mount the fireplace leveled on a flat solid
surface.
Install the control unit in the field of vision of
the outdoor fireplace and in such a way that
this is always protected from sunlight and rain
and out of the reach of children.
5.2 Electrical connection and cabling
The control unit has standard a cable with a
length of 8 meters.
With a connection for battery supply and for
the controlling.
Attention: The cables MAY NOT be
extended.
Longer cables can pick up environmental
signals that can switch the appliance
uncontrolled On or Off.
5.3 Gas connection
●
The gas connection must comply with the
local standards.
6 Installation instruction
6.1 General
●
Before installing the fireplace, the
exhaust connector must be mounted first,
place the exhaust connector on the
appliance and fix it with the 4 supplied
nuts. (see fig. 1.3)
●
ATTENTION: the temperature of the
exhaust pipe can become approx. 400°C,
keep this in mind if the exhaust pipe will
pass through a lean-to roof.
o
Install the outdoor fireplace
leveled on a solid surface, if this
is not present then create a
foundation The mounting holes
are located into the leg of the
appliance (see fig. 1.2)
o
First remove the cover plate by
means of 4 screws (see fig. 1.1
B )
6.2 Installation gas connection
Install a two-piece gas tap or a flat
connection as close as possible to the
connection (pipe nipple) of the fireplace. So
that for service and maintenance the burner
can be disassembled. (See fig. 1.4 and 1.5)
The appliance can be connected to both the
gas network and a gas cylinder.
The fireplace should be installed in
accordance with these installation
instructions and applicable national and local
regulations.
At an initial commissioning of a new
installation you should remove the air from
the gas pipe
Inspect the complete gas connection for
leaks.
TIP: For both natural gas or propane,
A flexible hose with gas (insert) socket is
available at Faber.
Please, contact your dealer for further
information. (Mertik Plug 1 connection)
Tips for safe use of gas cylinders
● Gas cylinders always must be standing
upright, both during use and transport.
● Place the cylinder at a minimum distance
of 1 meter from the fireplace.
●
Always use a pressure regulator between
the cylinder and the appliance. Replace
the pressure regulator every 5 years.
● Use an approved regulator according to
local regulations. Pay attention to the
correct supply pressure!
● Use only approved gas connection hoses
and replace it every 2 years.
●
NEVER fill gas cylinders with LPG. Leave
the filling of gas cylinders to an
authorized filling station.
● Replacing the gas cylinder:
1. Make sure the gas cylinder is placed in a
well ventilated area, away from ignition
sources (candles, cigarettes or other heat
sources).
2. Connect the pressure regulator to the gas
cylinder.
Use a good fitting wrench to unscrew the
pressure regulator.
check the gasket ring of the pressure
regulator.
3. You can now replace the gas cylinder.
Securing the pressure regulator goes in
reverse order.
Check all connections for possible gas
leakages.
You can do this with:
● brush with liquid detergent and
water.
● spray.