Faber theMOOD, Инструкция по установке и руководство пользователя, Страница: 8 / 16

7 < < < <
L
1 Introduction
We urgently advice to read this Installation
and User Instructions thoroughly.
This appliance complies with the guidelines
for European gas appliances (gas appliances
directive) and bears the CE mark.
Keep this Installation and User Instructions for
future reference.
2 Product Description
“theMOOD” is a gas appliance made of Corten
steel with a single-walled flue pipe of Ø
150 mm and is only intended for outdoor use.
The combustion air enters through the bottom
and through the gaps into the appliance.
2.1 Corten Steel
● Also known as weathering steel, is a
metal alloy consisting of iron to which
copper, phosphorus, silicon, nickel and
chromium are added. Characteristic of
Corten steel is both the brown orange rust
color and the durability. The lifetime is so
long because the first corrosion layer
(patina) prevents further corrosion caused
by rust.
●
The color
of the Corten steel develops further and
each product is unique. The final
appearance,-orange, terra, brown-,
depends on conditions such as humidity,
temperature and the extent to which the
product is exposed to the weather
conditions.
The steel gets its final color after about 2
years!
Keep in mind, that during the formation
of this “rust layer” on both the inside and
outside of the fireplace rusty water
comes from the material, this will leave
traces.
● ATTENTION: This “rust layer” (patina) is
the protective layer of the steel, if this is
removed the process will start over again.
For example, the presence of wet leaves
on Corten steel can leave spots behind on
steel.
3 Safety instructions
●
Operation area of the fireplace is
guaranteed off 0°
● We advise to install the outdoor fireplace
somewhat sheltered.
Advantages:
● Less wind sensitive and better
stability.
●
Intuitively more heat emission.
● The use of this outdoor fireplace in a
confined space is LIFE-THREATENING
and is PROHIBITED.
An installation area must have at least
25% wall surface open to ensure a good
ventilation, see detail drawing 2.5.
●
In extreme weather conditions we advise
to disassemble the flue pipe from the
fireplace and to cover the exhaust
connector.
● Close the gas tap or pressure regulator
after using the outdoor fireplace.
●
The outdoor fireplace should be installed
and annually checked in accordance with
these installation instructions and
applicable national and local regulations.
● Check whether the data on the
registration plate match the local type of
domestic gas and pressure. (for the
location of the identification plate, see
fig. 1.1
A )
● Do not put any combustible materials,
additional imitation logs or glowing coals
on the burner or in the combustion
chamber.
●
The settings and the construction of the
outdoor fireplace must not be changed!
●
The outdoor fireplace has been designed
for ambience and heating purposes. This
means that all surfaces, including the
glass can get approx. 250°C and the
exhaust pipe approx. 400°C. (Exceptions
to this are the control knobs)
●
Do not place any combustible materials
within 0.5 m of the radiation a
ria of the
glass. (See also Installation Instruction)
4 Unpacking the appliance
Inspect theMOOD for any transport damage.
Please, report transport damage always at
your supplier.
You will find:
1. Documents.
A. Instruction manual
B. Warranty Card
C. Log set card
2. Suction Lifters.
3. Glass.
4. Imitation log set with chips or
pebbles.
5. Control unit.
6. Exhaust Connector.
Not included:
1. Mounting material.
2. Pressure regulator.