Faber theMOOD, Инструкция по установке и руководство пользователя, Страница: 11 / 16

10 < < < <
L
card)
●
Start the fireplace as described in
Chapter 8.1.
Assess whether the flame-distribution
is good.
●
Position the glass and check the fire
image.
8 User Instruction
8.1 Igniting the pilot light
If the appliance has not been used for a long
time you may need to start several times
before the pilot flame ignites.
If you have not used the appliance for an
extended period of time, check the ignition of
the main burner at full and small position (the
ignition must be smooth and quietly).
After changing a gas cylinder,remove the air
from the gas pipe
●
Open the gas cylinder/gas tap.
● Press the start/stop knob B. (see fig. 3.1)
●
The pilot flame will ignite and when the
pilot flame burns the main burner
switches automatically to high position.
●
The ignition must be smooth and quietly.
● Operating the main burner goes by means
of the control knob
A for high and C for
low.
8.2 Turning off the pilot light
The pilot flame is turned off by means of a
press on the start/stop knob B. (see fig. 3.1)
We advise you to close the gas tap if you have
turned off the fireplace.
9 Instructing the client
●
Recommend that the appliance be
serviced annually by a qualified installer
in order to guarantee safe use and long
lifecycle.
● Point the customer on the service life of
the gas hose and pressure regulator.
● Advise and instruct the client about
maintenance and cleaning of the glass.
Emphasize the risk of burnt-in
fingerprints.
●
Instruct the customer on the operation of
the appliance.
● Hand over to the client:
o
Installation Instructions
o
Suction lifters
o
Log set card
10 Annual maintenance
10.1 Check:
In case of build-in, for service and
maintenance the two-piece gas tap or flat
coupling and electric cables are accessible
through the service hatch in the fireplace.
(see fig. 1.5)
Check and clean if necessary:
● The pilot flame, especially the
primary air opening. (see fig. 2.3)
● The burner, especially the primary air
opening. (see fig. 2.4)
● The glass.
●
Gas connection/gas hose and pressure
regulator.
●
Checking for gas leakage.
●
Ignite the burner as described in
section 8.1.
●
Check the ignition of the main burner
at full mark and low mark.
(the ignition must be quick and easy).
10.2 Cleaning the glass
Most of the deposits can be removed with a
dry cloth. You can use a ceramic hob cleaner
to clean the glass. Note: Prevent fingerprints
on the glass. They will burn in once the
fireplace is used and cannot be removed!
10.3 Conversion to a different type of
gas (e.g. natural gas)
This can only be done by installing a correct
burner unit. Please contact your supplier.
Always submit the type and serial number of
the fireplace when ordering.